Vervangende koolborstels voor T2000-serie, paar (2 stuks), Z104_1

COLE BRUSHES FOR LIQUID ELEMENTS DUAL ACTION POLISHERS

Replacement Cole Brushes for the popular No Swirls Dual-Action-Polishers... Set of 2 pieces.

Carbon Brushes will wear after a few years or when the DA-Polisher is heavily used. The DA-Polisher is not broken when it is making weird noise or will not run normally but the carbon brushes need to be replaced.

How to replace the carbon brushes.

• Replace always both carbon brushes in the machine.
• First be sure to shut down the machine and remove the power cord from the wall plug.
• Let the machine cool down for a few minutes to be sure you don’t burn your hand.
• Remove the screw at the back of the machine, just below the speed control.
• Gently remove the plastic housing-part of the machine and be sure everything stays in place

so it will fit the housing again when you put it together.

• Locate both carbon brushes and remove them gently 1 by 1

(be aware of the spring, it can jump out)

• After replacing both carbon brushes gently put back the plastic housing of the DA-Polisher and

screw it together.

• Put the power plug in the wall connector and turn the machine on at speed 1 to check if everything

is working properly.

• Let the DA-Polisher run for a minute so the carbon brushes are working perfectly.