Glö Hydrophobic Snow Foam

**NEW Protective Snow Foam** Add gloss and protection after the contact wash - effortlessly

What do you get if you mix Glatt and Snö? Glö. Combining the fun part (snow foaming) and the part we all crave (beads) into one process. To be used after pre-wash and contact wash stage. Layer on the foam like you would at the beginning, but rather than watching the dirt dribble away you'll watch (and hear) the foam crackle and disperse leaving your paintwork and glass looking unbelievably glossy and full of tall and proud beads. Rinse again and towel dry. The car will be glowing.

Apply it via a professional snow foam cannon with a pressure washer capable of 130bar or more for best results. You probably won't use all the mixture on a single car. At Stjärnagloss we reckon a litre of concentrate is good for 20-40 protective layers.

Buy our other new product - Snö X lntensive Snow Foam Pre-Wash

IMPORTANT - you must rinse out your snow foam cannon after using Glö, all hydrophobic/sealant snow foams can potentially gum up the snow foam cannon gauze/internals and prevent it working properly in the future. After applying Glö, simply run a litre of pure water through the snow foam lance to flush it through. Do this every time. We cannot accept liability for snow foam cannons that fail to perform properly after this product has been applied. If your snow foam cannon fails, new gauzes and lance cleaning/disassembly tips can be found online.