Ionisatie Water Filter - 0ppm

Car Water Filter For A Spotless Finish.

The final stage of any good car wash system is a pure water rinse that ensures a spot free finish. Now, thanks to the Aqua Gleam IN-LINE filter you can enjoy the benefits of virtually pure water, giving you a spot free finish when washing your car at home.

The Aqua Gleam IN-LINE 0ppm filter can filter the below quantities of water, we would expect an average of 8 litres to be used per rinse. There are many factors that can contribute to the lifecycle of any water filter, such as hard water sources, use from a water softener (due to added salt content), water from boreholes; and these numbers should be used as a guide only. The resin will change colour as it is “used” up and will need replacing once complete.

• Small (12″) – Hardness Water (Soft) – 480 Litres
• Small (12″) – Hardness Water (Medium) – 248 Litres
• Small (12″) – Hardness Water (Hard) – 160 Litres

• Large (30″) – Hardness Water (Soft) – 1200 Litres
• Large (30″) – Hardness Water (Medium) – 620 Litres
• Large (30″) – Hardness Water (Hard) – 400 Litres

Features & Benefits

• Eliminates watermarks & streaks
• Virtually pure de-ionised water
• No need to chamois dry
• Significantly enhanced shine
• Supplied with two quick connect hose end fittings
• Many other applications – motorcycles, boats, aircraft, motorhomes, etc
• Small – Length 350mm (13.7″) & Width 100mm (4″)
• Large – Length 805mm (31.7″) & Width 100mm (4″)

Purifies ordinary tap water to 0 parts per million (0ppm). Water at this higher level of purity will provide the best possible results and meet the requirements of even the most demanding users. In areas with particularly hard water it may be preferable to use a 30ppm filter rather than the 0ppm filter in order to prolong filter life. Alternatively a 30ppm can be used in-line with a 0ppm filter.

Instruction For Use

1) Wash your car with safe wash techniques, taking care to be thorough. 2) Rinse the soapy water away using regular tap water. 3) Do not allow the vehicle to dry. 4) Connect the Aqua Gleam IN-LINE filter with your hose using the connectors supplied. 5) Rinse the whole vehicle a second time. 6) Stand back and allow to air dry naturally for a spot free finished result.

Recommendations

• Reduce the water flow rate using an in-line regulator
• Keep the length of hose from the filter to the car as short as possible.
• The filter may be laid on the ground, however it is best suspended vertically with water in at the bottom
• Do not use in conjunction with a water softener or pressure washer (above 100psi).
• Only use enough water to re-wet all surfaces
• Use the filter in the same direction each time
• The colour change mechanism is affected by sunlight, drain after use and store in darkness
• The filter media will change colour to signal when replacement is due, even when the colour has changed, continue to use the filter until you are no longer satisfied with the result.
• Any fish smell is just a result of water being left in the media for too long after use, it will not impact the purifying ability.